![]() ![]() Establish a console session with devices R1, R2, R3, R4, R5 and SW1 than load the initial configurations provided below by copying the config from the textbox and pasting it into the respected routers console.If you are using GNS3 than load the Free CCNA Workbook GNS3 topology than start devices R1, R2, R3, R4, R5 and SW1.The following logical topology shown below is used in labs found through out Section 9 – Configuring OSPF This command is executed in privileged mode and displays interface parameters relating to OSPF configuration such as network type and hello/dead timers. This command is executed in interface configuration mode and configures the OSPF network type on a per interface basis. In this lab you will configure the interfaces of R1, R2, R4 and R5 as an OSPF point-to-multipoint network type and verify the configuration.įamiliarize yourself with the following new command(s) Command ![]() ![]() This lab is just to demonstrate how to configure the different OSPF network types. While mixing and matching the different OSPF network types may be required some some scenarios it is however outside of the scope of the CCNA objectives. Advertises the interface as a host route changeable by configuring the interface as point-to-point.The default OSPF network type only available to loopback interfaces. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |